My Cart

Close

EcoSeries Control Panel

$452.99

EcoSeries Control Panel

Airmax Plug & Play Control Panel

The ETL listed Plug & Play Control Panel is designed for use with the 1/2 Hp Ecoseries Fountain. Enclosure measures 9-1/2"H x 5-1/2"W x 4-1/2"D. Comes standard with a 1-year warranty.

Ready for Fountain & Light Set: This Control Panel includes two 115 volt outlets. One for aEcoSeries Fountain and one for a LED Fountain Light Set. Light sets sold separately.

Programmable 24-Hour Dial Timer: The dial and timer pins lets you run your fountain up to two cycles or for 24-hours, while a photocell will turn fountain lights on at dusk or off at dawn automatically.

Simple Installation: No hard wiring is required. Simply plug in the 24-inch power cord whip into a standard 115-volt outlet.

Ground-Fault Circuit Interrupter: Fast-acting circuit breaker which will shut off electrical power in the event of a ground fault.


Tech Specs

Airmax Plug and Play Control Panel
115V Control Panel
Fountain Applications 1/2 EcoSeries Fountain
Optional Fountain
Light Applications
Use with GGBW colour changing
LED Fountain Lights
Enclosure Dimensions 9-1/2"H x 5-1/2"W x 4-1/2"D
Included Features (2 Cycle) Programmable 24-Hour
Dial Timer and Photocell
Voltage 115 Volt
Whip Power Cord Length 24"
Protection GFCI
Warranty 1-Year

How to Install

Simply plug in the 24" power cord whip into a standard 115-volt outlet. No hard wiring required. The NEMA 3R Powder Coated Control Panel is designed for outdoor use but should be mounted at least 3-4" above any high water levels. We recommend using a licensed electrician to mount and install the control panel.

Step 1) Simply plug in the 24" power cord whip into a standard 115-volt outlet. No need to hardwire.

Step 2) Make sure GFCI's reset button is pushed in.

Step 3) Set timer pins to desired run cycles or 24 hours. a) If you are using your fountain for aeration, it is recommended to run the fountain a minimum of 10-12 hours per day, although running them longer can increase the benefits.

Step 4) Plug your fountain's power cord into the Control Panel outlet labeled "FOUNTAIN".

Step 5) If using a LED Fountain Light Set, plug the light set's power cord into the control panel outlet labeled "LIGHTS". a) Minor angular adjustments may be needed to the lights to ensure the lights are illuminating the spray pattern properly. b) Lights will only operate when the fountain is running and the photocell has activated the lights.


Note: Placing your control panel in a heavily shaded area or in a dark place will activate the lights continuously when the fountain is running.